Each method below produces different data. We explain which is appropriate for your Cameron, NC property situation before you commit.
Non-Viable
💨Spore Trap Air Sampling
Spore trap cassettes collect all airborne particles — viable and non-viable — and are analyzed under microscopy for mold genus identification and spore concentration. Results typically return in 24–48 hours from an accredited lab. Compared against an outdoor baseline, this data shows whether indoor spore counts are elevated and which genera are present. Standard method for routine Cameron, NC residential and commercial air quality assessment.
Viable
🏭Viable Culture Air Sampling
When genus ID isn't enough, viable culture plates give species-level confirmation. Critical for Stachybotrys chartarum investigation and situations where CFU counts and exact species matter — typically health-concern investigations and some insurance scenarios in Cameron, NC.
Surface
🎖Surface Swab & Tape Lift Sampling
Surface sampling confirms whether visible discoloration in your Cameron property is actually mold (not staining or efflorescence) and identifies the species present — affecting which removal protocol and PPE level is appropriate.
ERMI
🔋ERMI Floor Dust Sampling
Environmental Relative Moldiness Index (ERMI) sampling uses qPCR analysis on settled floor dust to identify and quantify 36 specific mold species — providing a historical picture of mold accumulation in a Cameron, NC property rather than a snapshot of current airborne levels. Used for post-remediation verification, long-term occupant health investigation, and situations where previous mold activity may have settled into dust but isn't actively airborne.
HVAC
🏢HVAC Register & Return Air Testing
Testing directly at HVAC supply registers and return grilles identifies whether the air distribution system is distributing mold spores throughout the property. Elevated counts at registers compared to room-level samples confirm the AHU or ductwork as the amplification source — critical before any duct cleaning or coil remediation decision in your Cameron building.
Clearance
📄Post-Remediation Clearance Testing
Independent post-remediation testing compares treated zone air samples to outdoor baseline — confirming indoor spore counts returned to acceptable levels before re-occupancy. Our Cameron, NC clearance testing uses the same accredited lab protocol as pre-remediation sampling, producing directly comparable data that demonstrates the remediation achieved its objective.
